When Jon first installed the system, he forgot to configure DNS servers on his Security Gateway. How could Jon configure DNS servers now that his Security Gateway is in production?

A. Login to the firewall using SSH and run cpconfig, then select Domain Name Servers.

B. Login to the firewall using SSH and run fwm, then select System Configuration and Domain Name Servers.

C. Login to the SmartDashboard, edit the firewall Gateway object, select the tab Interfaces, then Domain Name Servers.

D. Login to the firewall using SSH and run sysconfig, then select Domain Name Servers.

How can you check whether IP forwarding is enabled on an IP Security Appliance?

A. clish c show routing active enable

B. echo 1 > /proc/sys/net/ipv4/ip_forwarding

C. ipsofwd list

D. cat/proc/sys/net/ipv4/ip_forward

For normal packet transmission of an accepted communication to a host protected by a Security Gateway, how many lines per packet are recorded on a packet analyzer like Wireshark using fw monitor?

A. 2

B. 4

C. 3

D. None

Your main internal network 10.10.10.0/24 allows all traffic to the Internet using Hide NAT. You also have a small network 10.10.20.0/24 behind the internal router. You want to configure the kernel to translate the source address only when network 10.10.20.0 tries to access the Internet for HTTP, SMTP, and FTP services. Which of the following configurations will allow this network to access the Internet?

A. Configure three Manual Static NAT rules for network 10.10.20.0/24, one for each service

B. Configure one Manual Hide NAT rule for HTTP, FTP, and SMTP services for network 10.10.20.0/24

C. Configure Automatic Hide NAT on network 10.10.20.0/24 and then edit the Service column in the NAT Rule Base on the automatic rule

D. Configure Automatic Static NAT on network 10.10.20.0/24

What information is found in the SmartView Tracker Management log?

A. Most accessed Rule Base rule

B. Number of concurrent IKE negotiations

C. SIC revoke certificate event

D. Destination IP address