Correct Answer: B

References: Learning Plan: Designing and Implementing Cloud Connectivity v1.0 (ENCC 300-440) Exam Prep Designing and Implementing Cloud Connectivity (ENCC) v1.0 Cisco Multiprotocol Label Switching Exploring Cisco Cloud OnRamp for Colocation ENCC: Configuring IPsec VPN from Cisco IOS XE to AWS : [Deploying Cisco IOS VTI-Based Point-to-Point IPsec VPNs]

Correct Answer: D

A centralized data policy is a policy that is applied to all devices in the overlay network, regardless of the site list. A localized data policy is a policy that is applied only to the devices that are listed in the site list. In this case, the network

engineer wants to apply the policy to all devices in the overlay network, not just the specific devices in the site list. Therefore, a centralized data policy must be configured on the on-premises Cisco WAN edge router.

References:

Designing and Implementing Cloud Connectivity (ENCC) v1.0, Module 3:

Implementing Cloud Connectivity, Lesson 3: Implementing Cisco SD-WAN Cloud OnRamp for Colocation, Topic: Centralized Data Policy [Cisco SD-WAN Cloud OnRamp for Colocation Deployment Guide], Chapter:

Configuring Centralized Data Policy

Correct Answer: B

Correct Answer:

The configuration of cloud connectivity with Cisco Umbrella Secure Internet Gateway (SIG) in active/backup mode involves several steps. After configuring the SIG Credentials and SIG Feature Templates, the engineer must: Select the SIG provider for the primary tunnel: This is the first step in setting up the active/backup mode. The primary tunnel is the main connection path for the cloud connectivity.

Add the secondary tunnel: The secondary tunnel serves as a backup in case the primary tunnel fails. It ensures that the cloud connectivity remains uninterrupted even if there are issues with the primary tunnel. Create one high-availability pair using primary and secondary tunnels: This step involves pairing the primary and secondary tunnels to create a high-availability pair. Thisensures that the cloud connectivity will switch over to the secondary tunnel seamlessly if the primary tunnel fails. Edit the service-side VPN template to inject a service route: The final step involves modifying the VPN template on the service side to include a service route. This ensures that the traffic is correctly routed through the primary or secondary tunnel as needed.

References: Designing and Implementing Cloud Connectivity (ENCC) v1.01 Learning Plan: Designing and Implementing Cloud Connectivity v1.0 (ENCC 300- 440) Exam Prep2 Configure Umbrella SIG Tunnels for Active/Backup or Active/Active Scenarios - Cisco

Correct Answer:

Step 1 = Click Configuration, select Templates, and then select Feature Templates.

Step 2 = Click Add Template, select the device, and then click Select Template.

Step 3 = Click CLI Add-On Template and enter the name and description.

Step 4 = Paste the CLI configuration and then click Save.

The process of configuring a CLI add-on feature template in Cisco vManage for enhanced policy-based routing (ePBR) for IPv4 involves several steps1234. Click Configuration, select Templates, and then select Feature Templates: This is the

first step where you navigate to the Templates section in the Configuration menu of Cisco vManage.

Click Add Template, select the device, and then click Select Template: In this step, you add a new template for the device.

Click CLI Add-On Template and enter the name and description: After setting up the template, you select the CLI Add-On Template option, and then enter the name and description for the template.

Paste the CLI configuration and then click Save: Finally, you paste the CLI configuration into the template and save the changes.

References:

CLI Add-On Feature Templates - Cisco

Cisco Catalyst SD-WAN Systems and Interfaces Configuration Guide, Cisco IOS XE Catalyst SD-WAN Release 17.x - CLI Add-On Feature Templates Cisco SD-WAN vSmart CLI Template - NetworkLessons.com CLI Templates for Cisco XE

SD-WAN Routers