Refer to the exhibit

A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?

A. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration.

B. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family.

C. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family.

D. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.

Refer to the exhibit.

An engineer is viewing the CE1 routing table for CE2 Loopback 0. Each CE runs OSPF with its PE.

Which statement describes why the CE2 Loopback address is installed as an external OSPF route at the CE1 routing table?

A. PE1 and PE2 have mutual redistribution between OSPF and BGP.

B. CE2 is configured under OSPF with the command redistribute connected.

C. CE1 and CE2 are in different areas.

D. CE1 and CE2 have different OSPF processes.

E. PE1 and PE2 have different OSPF VRF processes.

Refer to the exhibit.

A large service provider is migrating device management from Layer 2 VLAN-based to Layer 3 IP-based solution. An engineer must configure the ISIS solution with these requirements:

1.

Network management server IP 172.16.10.1 must be advertised from the core MPLS network to the regional domain.

2.

The external network 202.10.0.0/24 must not establish ISIS peering with the R5 router.

3.

The regional network must prevent sending unnecessary hello packets and flooding the routing tables of the R5 router.

Which two ISIS parameters must be implemented to meet these requirements? (Choose two.)

A. LSP lifetime maximum

B. advertise-passive-only

C. overload bit passive

D. attached bit on ISIS instance

E. passive-interface Loopback0

How does Cisco MPLS TE use OSPF extensions to allow for optimized transit between a headend router and a destination router?

A. Router LSAs share router link advertisements to each router within the MPLS environment so that tunnels can be built bidirectionally.

B. ASBR Summary LSAs share OSPF domain information so that the two routers know how to reach each other during tunnel setup.

C. Network LSAs share RSVP information to build the tunnel between the two routers.

D. Opaque LSAs calculate and establish unidirectional tunnels that are set according to the network constraint.

A router is advertising multiple networks to its BGP neighbor in AS 5200 with peer IP address 1.1.1.1. Which configuration must be applied so that the router permits updates only for networks with a prefix mask length less than or equal to 21?

A. Option A

B. Option B

C. Option C

D. Option D