An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during a workshop about ESXi Host networking:

A total of 50 ESXi hosts to be configured as Transport Nodes.

All ESXi hosts have a dedicated 2 × Intel 10Gbps Physical Network adapter for the Overlay Traffic.

To achieve low latency, high throughput, redundancy, and performance, which two NIC teaming policies

should the architect recommend? (Choose two.)

A. Load Balance Source MAC

B. Load Balance Port ID

C. Load Balance Source

D. Load Balance Source Port ID

E. Failover Order

Which three choices are part of a Design Approach when discussing design alternatives and their effects? (Choose three.)

A. backup

B. budget

C. cost

D. performance

E. knowledge

F. security

An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution. This information was gathered by the architect during the Discover Task of the Engagement Lifecycle:

There are applications which use IPv6 addressing.

Network administrators are not familiar with NSX-T Data Center solutions.

Hosts can only be configured with two physical NICs.

There is an existing management cluster to deploy the NSX-T components.

Dynamic routing should be configured between the physical and virtual network.

There is a storage array available to deploy NSX-T components.

Which two requirements were documented by the architect? (Choose two.)

A. There are applications which use IPv6 addressing.

B. Dynamic routing should be configured between the physical and virtual network.

C. Hosts can only be configured with two physical NICs.

D. The storage array has enough capacity to deploy NSX components.

E. Network administrators are not familiar with NSX-T Data Center solutions.

Refer to the exhibit.

A financial company is adopting micro-services with the intent of simplifying network security. An NSX-T architect is proposing a NSX-T Data Center micro-segmentation logical design. The architect has created a diagram to share with the customer.

How many security levels will be implemented according to this Logical Design? (Choose the best answer.)

A. 5 levels

B. 3 levels

C. 9 levels

D. 4 levels

An administrator is asked to improve Recovery Point Objective (RPO) and Recovery Time Objective (RTO) for Disaster Recovery (DR) in their company network. The network has a primary site and a secondary site. The ability to support outages with minimum loss of connectivity to the company's core application is a priority.

Which design should the administrator recommend? (Choose the best answer.)

A. NSX-T Data Center using an Orchestrator to recover VMs across sites.

B. NSX-T Data Center using Federation and dependencies set between primary and secondary sites.

C. NSX-T Data Center using a registered third-party DR solution.

D. NSX-T Data Center using built-in standard automation DR and secondary site recovery setup.