A network engineer removes a new Dell Networking N-Series switch from the original shipping container and initially configures STP on the switch. While the engineer is working on another task, another individual modifies the VLAN 1 STP priority to 61440, and has saved to the startup configuration.

Which command should be issued to return the switch to the default STP priority value for VLAN 1?

A. console(config)#spanning-tree priority 4096

B. console(config)#spanning-tree priority 16384

C. console(config)#spanning-tree priority 32768

D. console(config)#spanning-tree priority 65536

An N-Series stack has been implemented. The network engineer needs to verify that all switches in the stack are running the same firmware.

Which command should be used to verify stack status?

A. Show run

B. Show stack-port all

C. Show stack

D. Show switch

A network engineer needs to summarize the IP range of addresses from 172.16.32.0 to 172.16.35.255. What is the most effective choice?

A. 172.16.32.0/23

B. 172.16.32.0/21

C. 172.16.32.0/22

D. 172.16.32.0/20

Refer to the exhibit.

Given the output from an N-Series switch shown, how many instances of VRF are running?

A. 4

B. 2

C. 3

D. 1

What are three characteristics of port-based VLANs on S-Series switches? (Choose three.)

A. FTOS supports 4093 port-based VLANs and one default VLAN.

B. Untagged interfaces do not need to be part of a VLAN.

C. Port-based VLANs should only be used in large-scale deployments.

D. Port-based VLANs offer increased security for traffic, conserve bandwidth, and allow switch segmentation.

E. Different VLANs do not communicate with each other unless IP routing is configured.

F. FTOS supports 4094 port-based VLANs and one default VLAN.