-- Exhibit -

--Exhibit -A vSphere administrator assigns VLAN 3389 to the Production port group on the VCP_DCV_Example vSphere Distributed Switch. After the change, users report a loss of connectivity to their applications. Further analysis provides the following data:

The cluster has not had a ESXi host failure.

Application functioned normally prior to the change.

The loss of connectivity occurred immediately following the change. Which condition would cause this loss of connectivity?

A.

The physical switch ports used by the vmnics have not been configured with 802.1Q.

B.

Maintenance Mode was initiated on one of the hosts in the cluster. Connectivity will resume after the virtual machines are migrated.

C.

All uplinks were removed from the VCP_DCV_Example switch and added to another virtual switch.

D.

A load balancing setting on the port group conflicts with the load balancing setting of the switch.

A vSphere administrator is configuring a fully automated DRS cluster and determines that DRS is not balancing virtual machine workloads. What condition could cause this behavior?

A. vMotion is not properly configured on the hosts in the cluster.

B. HA is not properly configured on the hosts in the cluster.

C. The DRS threshold is configured on the most aggressive setting.

D. Some of the virtual machines have been disabled from DRS.

While troubleshooting a crash event on an ESXi 5.x host, an administrator determines the log files related to the event are NOT present. Which action should the administrator take to resolve the logging issue?

A. Increase the amount of memory committed to log storage.

B. Increase the statistic data collection level to 4.

C. Change the roll-up type to maximum.

D. Create a persistent scratch location.

An administrator is migrating 135 virtual machines from a vSphere Standard Switch to a vSphere Distributed switch. The migration reports an error and only some of the virtual machines are transferred. What is causing the error to occur?

A. The vSphere Distributed Switch was created with a single, default port group.

B. The switch has become disconnected from an ESXi host.

C. The port group on the vSphere Distributed Switch was not configured with an Elastic port binding.

D. The virtual machine that failed to transfer did not have a network adapter.

During a physical network reconfiguration, an ESXi host briefly lost connection to the management network. High Availability (HA) began powering off the virtual machines residing on the affected host to be restarted on an unaffected host in the cluster.

Which setting should the administrator configure to prevent this behavior in the future?

A. Host isolation response

B. Host monitoring

C. VM monitoring

D. Admission control